Trd header bolts

I'm looking for someone to point me in the right direction to where I can get a set of spring bolts for my TRD headers on my 3.4 v6. This is the only thing that's holding me back from putting my engine back in my truck. Part numbers, thread pitch and other info would be helpful.

 

Bump. Anybody?? Try to have my truck trail ready for opening day of Uwharrie

 

Go into a muffler shop and they should have a variety of springs to sell you. Then run over to the hardware store and get the proper size nuts and bolts to fit the flanges with the springs installed. They aren't anything special. I had to do the same thing when I installed mine.

 

10-4 I didn't know if there was a kit available for it or not. Have you had any problems with leaks?

 

No, it sealed up wonderfully. I reused the cone shaped gaskets that the used headers came with too. I think there use to be a "hardware" kit available through TRD but like the headers them selves its impossible to find now.

 

10-4 thanks man. Did you torque them to anything specific or just tightened the hell out of them

 

Have you tried contacting TRD to see what they say? Legally I believe they have to supply parts for anything they used to sell for 10 years after it's been discontinued. Might be a pain in the ass to track down though, I'd try seeing what a local muffler shop can do to help you out.

 

I talked to them about gaskets here a while back and they said they couldn't get them anymore so I'm assuming it'll be the same thing with the bolts. I'll probably just go to a muffler shop and see if they can help me out

 

Were you able to locate all the gaskets and bolts for the header install? I'm struggling to find stuff