Rigid Ignite Flush Mount Pods on Rear Bumper

As requested! But pics don't do it justice. The light output is amazing.

 

The 3rd brake light (at least on the Pro) is led, as is the led bed kit- all that less than an amp draw. Adding another 1.5 to 2 amps has to be safe.
I'll find out if I start popping fuses, but feel pretty safe here.

 

Mimicking is the highest form of flattery...
Spliced em right into the OEM bed light harness. 60 minute install with proper splice and solder.
They come on when the bed lights come on (door open or with the dash switch).

 

I've been thinking about getting a pair of these to mount on my Relentless Fab bed rails.

 

Was this as simple as drilling the proper diameter holes in the rear bumper for the install?

 

Meeeh, you have to do some good measuring and make a square hole with a dremel, it makes it much easier. There is not much space behind the plastic trim for error.

 

There is like zero room for error.

Anyone know of a cheaper flush mount light that would fit?

 

Plenty of room for error.
You install with 1.75in hole saw.

Measure twice and cut once.
I can't remember the measurement I made to find center, but the only thing to watch out for is the steel hitch behind the plastic. Just eyeball center based off the pics you see here- measure on both sides and cut the hole.

 

oh the steel hitch..... i had a fun time with that... just barely had to take the corner out... if i was half an inch lower it would have been 60 min instead of two hours..

 

Just in case someone needs it in the future, I made a better template.

 

I definitely need to add this to the list of mods , looks great.

 

I cheated.