What Have You Done To Your 2nd Gen Tacoma Today?

Even gave the wife's ride a bit of love today

 

Installed some Grillcraft upper and lower grilles.

 

Really like that lower grill a lot.

 

Cool. That's what the inside of a RC looks like! I don't think I've ever seen one in the wild.

 

Cut down the tonneau cover levers to fit past the bed extender. Cut majority of it off with an angle grinder then filed the ends smooth with a simple flat file.

 

yeah, i figured if i was going to replace the grille, i might as well do the whole thing.

 

Not that they are needed now that spring is here, but the heated seats are installed and ready for fall / winter.



.... hog clips are the worst.

 

Nerf bars for the wifey.

 

How much the 30k service run you?

 

Let air out of the tires, drive it in, do the work, drive it out, air up the tires.

 

Looking Good! How do you like the NGK plugs?

 

Clayed the truck today. Tried to get these suction cup marks off from where a PDR guy fixed a dent in my bed. His light used to identify the dent used a suction cup to stay on the bed. Clay wouldnt bring it off, neither would rubbing alcohol or good-gone. Any suggestions?

 

Tried that. Also have to remove roof rack and RTT to get in the door. At that point it's easier to just do the work outside for most stuff.

 

I've had great results with 3M rubbing compound. I purchased it at NAPA.

 

Fap fap fap

 

Oil, differential, and a nice wash...had to give the little guy some love too

 

Thanks.

Runs just fine.

 

Whatever this did.

 

Mid 70's today (normally in 50's) so I did the following:

First hand wash of 2017
Vacuumed interior
Cleaned Windows
Washed floor mats
Quick interior detail
Cleaned out winter crap from bed, cleaned bed, bed mat & cap windows
Installed bed platform for the summer

 

ARB compressor ready to rock.