Bilstein 6112 Install

@SNOWTACO72 no I left them on the 4th setting, I like the height, it's a little over 2.5

 

Does this look right? Both sides are the same save for a 1/4" top plate spacer on the driver's side. Springs are 650# Eibach since I'll be adding bumpers etc very soon. Sorry for the bad pic as I ran out to the garage with the iPad.

 

I got 6112. What was the recommendation for rears? Not doing any lift, sticking to stock height to not mess with the truck. I just want a better suspension setup for my 4x4 SR5.

 

Working on PM now

 

This is what I'm looking at getting: Bilstein 6112 strut and spring + rear 5100 shocks for my 2015 Limited DCLB 4x4, Amazon for $782,,,not looking to lift the rear, but hoping the rear 5100 will be a little taller than stock, set the fronts at the 3rd notch, that should give me 2" lift on front and level, correct? Plus not having to change the UCA's or drop kit. I go down so many rabbit holes trying to decide lol, you guys have amazing setups, out of my league, I'm not an offroad guy, I tow an 18' flats boat though, I just like the level look. I don't want an AAL or blocks either, just KISS
Also after that put some 275/65 18's on there, will they fit without trimming?
Thanks everyone

 

This is the wife's Taco on 285/70/17's. Put eibach (Toytec branded 620 lb) 1.6" lift coils on 5100's, did factory recall leaves, and 5100's out back. It has finally broken in after 5k miles and is super smooth. It was incredibly stiff at first. I run a FOX setup on my yotota and super cushy. Hers is the "road truck" so it hasn't been wheeled. I jump mine. Had to do some fender trimming to fit those tires, but no scrubbing now. Look into Wheelers Off-road super bumps. Put them on both Tacos and they are amazing. Intake pic is what I put on hers. Straight up amazing for the price. Sounds like a monster and pulls like one. Just my two cents.

 

Hello,

I am confirming some info. I bought my 6112 from @HeadStrong Off-Road back in 2016 when I bought my truck.

I understand that the current 6112 have 5 adjustment settings while there older generation have 6 clip settings.

Is this accurate?

 

Bump

 

Post in error