What Have You Done To Your 2nd Gen Tacoma Today?

You didn't have one of these, did you??

 

Yeah, I have a couple of thule cross bars.. I might try mounting them up there or perhaps some brackets that attach near the taillights. I've also seen folks on here mount them on their racks, but wanted to try to get the lights down a little lower

 

Haha its the opposite actually. I love helping friends if only because when I need something I can cash in 1 of many IOU's.

 

Now this is why you should alway remember to take the 30 seconds to check your cabin filter.

 

Bought a Wavian jerry can. Now I can get lost FARTHER out in the Utah desert!

 

At least you had one...

 

Sounds like a good plan.

 

That's a good point.

 

Correct, tt uses the window mount. There were two rubbed isolators in between the window and fiberglass, I took them apart and sandwiched the t-bracket in between them. I was a bit nervous mounting it to the window, but its solid and does not contact the glass in this setup. It is mounted to the same point, but isolated from the glass by the rubber spacers SnugTop had there to begin with. I might change it down the road to a more permanent solution. A roof rack would be good, but I don't run mine all the time since its a commuter and the garage at work is a bit short. Without it I have 3" of clearance.

Nilight:

$15 Nilight Led Pods 2Pcs 18W 1260LM Spot Led Off Road Lights Super Bright Driving Fog Boat Lights Led Work Light Bar for Trucks Pickup Golf Cart SUV ATV UTV 4x4 Van Camper,2 Years Warranty

https://www.amazon.com/gp/product/B00G620ZVU/ref=oh_aui_detailpage_o00_s01?ie=UTF8&psc=1 They were cheap ($16 from Amazon warehouse) and I resealed them with silicon since I am not sure about their waterproofness. We'll see how they hold up. I figured for backup lights it was a decent price.

 

Found this on my truck...does this count as a mod?!?! lol atleast someone likes me.

 

Out with the old, in with the new. Got the rear ADS done, 2.5" with 700# springs and RR's with compression adjusters. Took right around 2 hours with beer breaks. Came inside to rest, because the heat in July in Texas is a rude bastard. I'll take her down the road later and give my feedback.

 

Here is the finished product. ADS fronts and rears

 

i vacuum mine out on occasion. Usually when I'm doing wiring and pulling the dash apart anyways. Pull the footrest and kick panel as well. Lots of dirt/rocks collect there as well.

 

Mine was much worse than that!

 

They get pretty nasty!

 

Took it off road for a few miles. Not bad for the stock suspension.

 

Cleaned MAF sensor and throttle body, fixed the compass/temperature display and sanded/painted the bed bolts and tie downs.

 

I had my front billy's (5100 @ 1.75") installed!

 

Who's gonna get them on first?!?!?! @ChadsPride or @kiahb12

 

Definitely @kiahb12