Total chaos gusseted spindles

Can I get in on this? What do you need from me?

 

What else you welding Jason? You got skills and the welds you did for me looked money

 

What sized steel are you using to make the gussets for the tie rod arm?

 

It's 10ga. They are included in the tc gusset kits. I use 10guage on the gussets I add to the non sway bar kits as well

 

Awesome, I was gonna get the non sway bar gussets and add the tie rod gusset in. Thank you much.

 

I don't get around to updating it often but here's some of the stuff I work on. Thanks.

https://www.tacomaworld.com/threads...ars-rack-cmcs-certified-welder-so-cal.379771/

 

Definetly. I shoot you a pm when I take my lunch break

 

Group ship?
I have my spindles an my gussests just not a welder

 

I'm interested in getting a set of spindles from you that retain the swaybar. But I have some questions on some custom alterations that I want to ask about. Sending IM.

 

@CO MTN Steve
Yea we were talking about them, this is the thread.

 

@CO MTN Steve again

 

I need a set please.

 

Thanks Man

 

question. Does anyone know if there is a difference between the 2nd gen and 3rd gen spindles? I have some off a 3rd gen and I have a 2nd gen.

 

They are the same

 

O THANK GOD! I basically stole them from the seller but he didn't care. But I was shitting a brick not knowing if they fit. I cross threaded the bolt going from the LCA into the spindle and I re-threaded the hole and then ground the bad threads off the bolt but been wanting to replace the spindles.

 

You're good

 

Found enough time to get a set of these welded up and headed off to @dbrfan in Hawaii

 

Received yesterday and installed today, thanks @glorifiedwelder!!