Dual Swing Outs for 2nd Gen?

I don't have pictures with me so I'll update this post in the morning....if that's what you were hinting at.

Just one picture of the right side open all the way. The other side can do the same if I so choose...

 

no no I was just quoting because the OP was asking something that had been already answered in the thread! but thanks sure pics never hurt lol

 

There are local fabricators that can do the high clearance with dual swing out. Hit up @3378jakesr5

 

Nope, I was asking a different question about how far the swing outs could open.

 

ahhh interesting you mean like have the gate down and the two tables all open like one wide bench ??

 

Yeah exactly. Almost like an extension to each side of the tailgate.

 

Is yours a high clearance, or just a bumper replacement?

How much did it cost?

 

Regular height bumper. Cost with the dual swings, hi-lift mount, dual gas can mount, two fold down tables and all powder coated was about $2600.

 

Are there multiple locking points when opening?

 

Whats the weight on this? Is it steel or aluminum? If steel, do they make an aluminum?

 

I have two on each swing out....as above in the quoted post, both can either lock at 90* (as on the left side) or both can lock at just about 180* (as on the right side).

 

My ideal

Thanks!

 

Steel...not available in aluminum as far as I know. Weight per CBI is 165lbs for single swing out without gas carrier. I'm guessing with two full 5 gal gas cans, Highlift jack and a 265/70R17 Duratrac puts the total weight at easily 250+lbs.

 

My ideal dual swing out high clearance rear bumper:

@RelentlessFab ALUMINUM high clearance rear bumper boxed to carry water

- side note, what is the cut out below the tail light for, highlight jack recovery point?

With additional water tank like Total Chaos's 2014 build:
http://www.chaosfab.com/Toyota-Tacoma-4x4

The water pump tucked away like at TC's 2014 build as well:


With AEV swing out tire carrier to carry spare, fuel caddy, backup light, high lift and pull pal:

Fuel Caddy

Back up light


With All Pro's Driver Side Rear Swing out that carry's a cooler, and have a table on both inner sides of the swing out like @Sna 's CBI Dual swing out drop tables and locking points.

 

All pro makes a bed rack that will go over a softopper, I think BAMF does as well but not positive

 

someone with an All-Pro please post. this is probably going to be my next $ pain point.

thanks

 

do you have a side shot of the high clearance bumper side?

 

I see there is only 1 latch. If you open the one latch does it open both sides? Or are you able to open one side at a time? Does only one side lock or do both sides lock?

 

One latch so when released the right side opens and then the left side. Both sides lock at 90*.

 

hey, thanks for bumping this old thread.

i now have an All-Pro dual swing out and i just dropped it for some service. i need to know the size of the castle nut holding the arms on. anyone?