Long Travel BS Thread

torch the threaded side for 15-20 seconds. You'll be surprised how easily it'll come out after a little heat

 

They're able to generate more torque w/o stripping based on the design - more like impact sockets.

 

Need to find one of those as well, that's awesome you came up on that for that cheap

 

Call them

 

Looks like a Torx in the middle there

 

Tried heat with a torch. Still won’t move.

 

Ya and everyone said Allen it and heat and penetrating oil no luck

 

Get it red hot and that sucker'll come out.

 

Heat plus impact. Or use one of these with a hammer

 

Sounds like you need to put a piece of pipe on that allen for more leverage. Or just use a 1/2" impact if you have that available to you.

 

I see the silver Allen head is bigger on the outside. Do you have the Torx bit for the rusty inside bit? I'd try the Torx and an impact driver

 

What is that? Link?

 

I tried the pipe just was scared to strip it.

 

manual impact. http://www.sears.com/craftsman-impact-driver/p-00947641000P

also in addition to the heat, smack the threaded end of the bolt with a punch and hammer.

 

Works great. Best part is the stress relief it provides. You get to beat the shit out of the seized hardware WHILE breaking is loose.

 

I got this kit http://giantmotorsports.com/index.php/product/tacoma-2005-2014-64-long-travel-leaf-spring-kit/ . I can feel the whole cab vibrate like crazy during low miles just driving around. I was recommended to go to J E Reel at Pomona, maybe he can do something about it.

 

Fucking u-joints suck when they are rusted to the yoke. That's all.

 

At droop I have 6 degrees of angle, compression 0 degrees of angle and it was set at 4 degrees at ride height. He's telling me the diff moves alot and is bound to bind the carrier bearing.

 

Where did you find the video?