Quick disconnect sway bar end links

Maybe we can start a group buy for the 01-04 1st gen? If your up for it.

 

I would be in for a 01-04 set.

 

No problem I can do that

 

man those look a lot better than anything I've seen on the Interweb. Any chance you've made anymore and have them lying around? My 2000 Taco "Bessy" sure would love a set, especially since I've gotta swerve for all these damn deer up here in oregon.

 

I don't have any laying around, but I can make you a set. I'm going to make a group buy soon, if you can't wait just send me a pm and I can send a set out to you sooner.

 

Update to the 01-04 guys.

I haven't forgot about you guys who are still wanting sets.

It should only be a few more weeks of testing before I put up the group buy.

If anyone is in Arizona and would like to help in the r&d process, send me a pm

 

Interested as well for a 99 tacoma 4x4.. Let me know if you have some available for my year truck. Thanks

 

+1

 

Im in for a set for a 00

 

Hey guys with the 01-04 tacoma, need some help with the measurements for your trucks. I have some numbers from a member that was helping, but i just want to get a consensus before i start the group buy.

Please let me know if your truck has a lift, and what the lift height is. and if all possible use a measuring caliper not a tape measure, so we have some accurate numbers.

Need two measurements needed:

1.)the distance from the center of the hole on your lower control arm(bottom mounting hole for sway bar end link) to the center of the hole of the sway bar(top mounting hole for the sway bar end link).

If your running you stock end links now, with a three inch lift, I'm sure there is a small rake(angle down).

so if all possible, take the measurement with the sway bar perpendicular with the frame of your truck.

2.)the diameter of the hole in the sway bar.

if you have any questions please done hesitate to ask. private message or post

thanks guys

 

sub'd interested in 01-04

 

Interested.. subbed

 

I'd be in for a set for 01-04 as well. What's the size of that pin though? Seems like there would be quite a bit of stress on a very small pin?

 

I'm interested for '04 for sure.

 

Interest in a set for an 2004

 

I'm in on a 01-04 set.

 

Definitely interested in a set for a 3rd gen.

 

I just found this on the 1st gen stickies
http://www.parksoffroad.com/tacomamods/swaybar.html

 

I also have tools with me when I go wheeling. I think I'll just take that nut off if I'm going to hit a hard trail.

 

Hey @1stevertaco. Just checking back in to see if you are still interested in offering these disconnects for late 1st gen models?