Wiring schematic for 2017 tacoma jbl audio?

Its been a while since I did an audio job... hahaha. The high low is for the input voltage signal, which I need to check tomorrow with a volt meter to determine which setting to use. As far as where to plug in the REM, I would appreciate it. Thanks.

 

Im curious how you know how the amp is properly getting the audio if you havnt got it turning on yet from a remote wire? Just for my own info. Im looking for fuse number are you familiar with add a fuses? For sure you can pull radio out which is super easy and tap the grey wire. But if you dont wsnt to do that (takes 3 min) then the fuse works

 

Ok so you can tap the sun roof, doors, p/w for power windows, or outlet fuses it looks like by looking at the fuse cover

 

Thanks. I jumped the hot terminal to the REM temporarily to make sure everything was working. Thanks again, will check it out tomorrow.

 

I think I F'd up... I don't know if it is due to tapping into the constant 12v in the center plug for the jbl amp - pink wire. But now I have no volume in ANY speaker, and I no longer have 12v on that pink wire. Please tell me there is a fuse for this, and I did not destroy a brand new head unit, OMG my wife is going to kill me. PLEASE HELP!!!! Thanks.

 

I found the problem!!!! F'n A... I literally shit my pants while getting ready to tell my wife I screwed up her truck... When looking at fuses under the hood, I accidentally pulled the Radio 2 fuse and inserted it into a dead fuse holder. Looked at the fuse schematic on the cover and found. Jesus Christ, I almost had a heart attack...