1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Zerk fittings

Discussion in 'Technical Chat' started by MaGuyver, May 3, 2010.

  1. May 3, 2010 at 11:30 AM
    #1
    MaGuyver

    MaGuyver [OP] Well-Known Member

    Joined:
    Jan 24, 2008
    Member:
    #4408
    Messages:
    256
    Savannah, Ga.
    Vehicle:
    2020 Tacoma Sport, Cement
    Tinted glass, Bed mat, Rigid light bar, Bakflip FiberMax tonneau, Bull bar, LED cabin lights, Bed lights.
    I now have bump or thump on my 07’ 4dr (non-4wd) Tacoma when I stop and the release the break a little. I had it on my 2004 but that was from day one and on this one it has just started at 34000 miles. I have read a number of posts on diff. sites about what you should do or what might be the problem. I just need to know if there are zerk fittings on my vehicles’ drive train? Thanks
     
  2. May 3, 2010 at 3:58 PM
    #2
    Isthatahemi

    Isthatahemi Well-Known Member

    Joined:
    Apr 29, 2009
    Member:
    #16582
    Messages:
    1,142
    Gender:
    Male
    Vehicle:
    TRD OFF ROAD
    BFG AT's, Weathertechs, Hoppy's brake controller.
    I think greasing the slip joint can help....
     
  3. May 5, 2010 at 2:49 PM
    #3
    BRP27

    BRP27 When I grow up I want to be just like Me

    Joined:
    Oct 16, 2009
    Member:
    #24381
    Messages:
    426
    Gender:
    Male
    So far south in Texas my feet are in salt water
    Vehicle:
    04 4X4 Tacoma SR5
    3 in Ultimate ToyTec, set @ 2.5 in. AAL PINCH Weld Mod ( beat the pinch weld over inside the fender) Painted the pinch weld on bottom of cab Black Hi Lift Knock off
    There are zerk fittings on the drive shaft. Dont put more than a few pumps on the gun into the slip joint, a couple is all you need.
     

Products Discussed in

To Top