My silver build

Haha. First off thanks, secondly Ill probsbly keep it incase I end up not liking this. But so far its nice.

 

https://www.tacomaworld.com/threads/wiring-toyota-push-buttons-for-led.536925/#post-17286458

 

Well I had the opportunity to pic up a great 3 person RTT on a custom made fully offroad military trailer. After careful consideration I went with a tent trailer. Reasons for this is that I can hang out inside when waling up in morning before my kids, when its pouring, or for lunchtime etc. Ill use it and venture off from the campsites for trail runs.

 

Looks great Travis

 

Swapped front steal skid for aluminum. Love this skid @EddyRRT. Half the weight of that heavy ass steal so lets hope it holds. Also extended rear diff breather.

 

Nice.. how would you rank effort vs reward in the sound deadening there? I did my 4 door panels when I replaced speakers and it seems like it helped quite a bit, so I’m considering doing behind the back seats as well, just not sure yet.

 

Effort was more cause i have vents and power window motor but even then it took me 30 min. It made a huge difference. Completely eliminated my turn down exhaust cabin drone thats below rear passenger seat. I am so glad i did it. I say definitly do it for sure.

 

Nice man that’s what I was hoping to hear! Thanks. Did you follow a guide/write up or just kinda wing it? As far as finding the screws and fasteners etc

 

Not sure what you mean by screws fasteners? The sound material is just peal and stick. I completely covered the rear panel exposing only one gromet on rear wall. As far as screws i threw away my bins so i covered the old holes right up. You could just cut out small parts where holes are to keep them exposed

 

Ah I’m sorry I meant to remove the bins before you started dynamatting.. I was planning on dynamat then putting the bins back on?

 

to remove bins i folded down seats. On each seat there is two bolt covers. Pop then off and undo seat bolts i think its a 14mm socket. Then take seat backs out of truck. Then u will see bolts holding on bins. Once those are removed u have to grab the bins firmly and pull hard then snap out of place but take some pull to get them to release. I did not put mine back in cause i replaced them with that molle panel for all my offroad/recovery gear pouches. But ya u could re-install it. With seat removed i also folded back carpet and did rear seat floor. Think that helped alot as well

 

Awesome thanks again man!

 

awesome build man! local to me in chino!

 

Sweet. I see all sorts of built tacos daily out here. Love it.

 

Cobra 75 in. Ham radio test later this summer. No antenna installed yet but got the tailgate bracket on.

 

As she sits 6/1/18

Big changes coming to the truck. Front and rear plate bumpers on order, front/ rear anytime cameras on order, switch pro style controller awaiting install, hids for the faux pro headlights and baja design lights on order. Cant wait!

 

what bulbs? I find my red LEDs too dark