What Have You Done To Your 2nd Gen Tacoma Today?

I'm going to do all of my doors (double cab Tacoma) and behind the rear storage compartments. The one I linked to is supposed to be enough to cover all of that. Headliner would be a good area to do also, but more of a pain to access.

 

That does quite a lot for that price! I may do it too. Going with a taco tunes setup in the future. Yes, headliner removal sounds joyful.

 

Congrats on retirement!

 

Thanks! They stick out a little more than what I was thinking going off of the original pics. Truck looks good! Are you getting lift installed today? Which kit did you go with?

 

Just a 2" leveling kit by rough country

 

That just lifts the front, right?

 

Yeah a 2" lift in the front to level the truck out to match the back

 

Well I did my Flag yesterday and today, I finally installed my CB Radio. I've had the CB now for about 2yrs lol and all the stuff to install it for about 4 months and I finally found the time to do it lol. Now I have to tune it

 

Really easy, run masking tape in the middle, measure how spread apart you want the tracks (mine are same width as the cab rails because I wanted as close as possible to the sides to have the weight down directly into he bed sides).

Lay tape at that distance each side, then place rail and make sure you have same distance from the back easier to measure a distance from the brake light in the cebter then trace on each side.

Tape the bar so that it follows the roof curve and mark all holes.

Pre-drill

Drill

Silicone bead around and in the hole

Put the screws

Have someone old the Allen key on top while you screw the nuts inside. Use a drill because it has like 1" too long thread inside and by hand it will take forever.

Then trim the excess threads and put caps

Super easy

 

Before




After
Powdercoated rear chrome bumper to color match MGM and did black bolts in Method NV’s

 

Buzzer delete mod is one of my favorite mods!

Noico hands down

 

Installed Cali raised ditch light brackets, and led pods. Color matched the fronts of the pods to match my color scheme!

 

Picked up one of these to carry just in case a ford or Gm need a jump!
Or maybe I forget to turn off extras I’ve added.

 

I finally had some time to illuminate my 4x4 switch

 

Looks great

 

Finished the tool mounts:

 

Which method did you go w/?

 

I followed the instructions from @rcbs204. I soldered to the switch then ran the leads to the AC feed.

 

Im going to have to make me a new sub box for my yukon now

 

Went to early vote