What have you done to your Tacoma today? 1st Gen Edition

I think you can get that foam gasket (which is failure prone) from Better Bed Lights if you needed one. They started producing a slightly thicker one to accompany their light mount.

 

I ended up buying one off of eBay.

The parts guys couldn't believe that it's not sold separate

 

Ordered some custom plates today for my taco. Been wanting some for a while but couldn't think of anything I liked till now.

 

Anyone have the link to the water pump/timing kit?

 

https://www.ebay.com/itm/15-Piece-3...9UF0SF:sc:USPSPriorityFlatRateBox!35055!US!-1

 

Tried a simple turn signal relocate with this doodad. Drill a 1/2" hole and pop it in.

$9 2x Connectors Socket Bulb Light Harness PigTail T10 168 194 rubber wedge LED

https://www.amazon.com/dp/B01FSY2MVM/ref=cm_sw_r_cp_apa_7r-RBbJCG95RH

And these LEDs.

$13 Alla Lighting T10 Wedge Amber Yellow 194NA 194 168 2825 175 W5W W10W LED Bulbs Super Bright High Power 3014 18-SMD Side Marker Lights/Interior Lights Lamp Replacement

https://www.amazon.com/dp/B01CHW0IQ4/ref=cm_sw_r_cp_apa_Tt-RBbYPJ1BXV

I guess the key to success is finding the brightest T10 LED.

ARB turn signal for comparison.

 

I like that.

 

I've been wanting to relocate the turn signals but didn't like any of the solutions I found. Ran across a video of a guy relocating his (on an Acura I think) using and old Honda socket. Looked very similar to the ones I used.

These sockets make it really easy.

 

Ima have to keep them in mind

 

Link to kit and tools, and a step by step

https://adventuretaco.com/step-by-s...r-3-4l-v6-5vzfe-also-4runner-tundra-and-t100/

 

Shouldn't you be camping?

 

If he is he’s waaaay ahead of Monte

 

We are, and we have service. It sux! Hahahahaha

I think Monte would say that "today didn't go quite as planned" for him... Hahaha

But, he still promises to be on time tomorrow. Right now, the over/under I've got with Mike is 2 hours late.

 

Where are you jerks headed if you don’t mind me asking?

 

What's size speakers??

 

I cant find the link for the engine gasket set. Can anyone help me out with that?

 

I added some rock lights! Also redid some electrical Big 3 upgrade and fuse box panel.

https://youtu.be/Hx93wo-G8D0

 

TBD. I have not had a lot of time on it the last two days, but it is getting better. Need the fender to calibrate how far off it is now.

I straightened out the front body mount (a little heatin and beatin) that was sheared off using torch and porta power. I will be welding it on later today. I think that lower part of the front end is almost where it should be. The upper part of the apron is still off.

 

looks like your making some pretty good progress pretty qucik

 

Yeah. Driving without a sway bar on 20 year old shot suspension is not a matter of bravery, it's a matter of safety.