How to wire rear facing pods?

anyone have a link to a thread on how to wire rear facing pods?

 

It's more about when you want to have them come on.
On/off Switch. Reverse...both..
Power only on when keys are in or would you like to have them come on even with keys out of ignition.?
Once we know that....Then one of us could link you to a good wiring diagram or atleast steer you towards a thread that covers it.

 

Looking to install them with "ON/OFF switch"

 

Than most any aux wiring thread should work with only differences being...running wire to the aux lighting.

https://www.google.com/url?sa=t&sou...ghDMAo&usg=AFQjCNFqAHOprYXkUXoP6QZ9HgGuZN2DNg

 

thanks!

 

I am looking for reference on how to wire to reverse lights plus a Rocker switch plus a kill switch for wiring into reverse. Any guidance or reference would be appreciated

 

Most of that info should be in post #4's link

 

I just wired these yesterday, on/off switch.

 

Very nice..
I went with them in the bumper..

 

did you use the link above for reference? can you post pictures of how you ran the wires and where you tapped into? Thanks!!

 

Didn’t use the link, I just used a wiring harness with the lights. I’ll try and get some pics, but it’s as easy as can be. I ran most of the wire along the frame, with the factory wiring harness.

 

This is how I have my lights so far but I haven’t wired them in yet. How did you wire the pods from the outside to inside the cab?

 

I’m about to build my own bed stiffeners, and I’ll will mount the wires to them....nice and tidy.

 

But how are you running your wires? Just on the sides of the truck bed? Or underneath or how?

 

Sorry. I went under the bed and along the frame rails. There is a factory harness that runs most of the way, I followed it. Under the engine bay the into the grommet that comes out by the break pedal.

 

Why not notch the bed side caps and drop the wires down within the bedside and run along the frame from there? I've used a couple of Rigid wiring harnesses and like them and switched mine inside the cab with switches from Air on Board

 

Were you able to use the one harness for both lights? or did you need to splice into it with more wire? I'm surprised there was enough length to get to the cab.

 

I spliced them together, I also added wire in the middle of the harness.

 

Thanks, I'm waiting on a back order at my local shop for the same cali raised mounts. I'll see if I can copy you in a months time.

If you have any other install photos I'm sure they'd be appreciated.