1st Gen Lunchtable Thread - General Discussion

While it's of course preferentially subjective I like them (not with bad black / crisscrossed spray pattern style paint). I like this guy's method:

 

sup

 

What's it like to be semi-banned - asking for a friend?

 

it's like being hungover

 

@BartMaster1234 you can see the 2nd bolt right on top of the bottom most horn. I welded a 1/2" nut to the back of the bar to act as a spacer as it was the same height as the support.

 

Good answer. Party now, pay for it later. Been there.

 

Hey I need a CB. Does anyone know if this is the right part ? Thanks

$94 Spicer 211750-1X Center Bearing

https://www.amazon.com/gp/product/B00GAPFD2E/ref=ox_sc_mini_detail?ie=UTF8&psc=1&smid=AD3MTLRZCVAGX

 

This is probably what @BartMaster1234's house will look like one day - can't drive by this house without saying that to myself.

 

good lord what are they listening to, deep space?

 

It ain't that bad

 

@BTB

Just gets urself one of these bad boys

 

Is that diy?

What / how many accessories are you adding?

 

Combination relay/fuse box. Make it easy to connect a bunch of accessories and wire switches all at once without a bunch of clutter

 

How do you like that crimper? Right now I'm using some vice dies but they are kinda awkward to use and not precise.

 

Bought a mostly assembled box and did the main power and relay ground myself as well as the box mount and breaker mount.

 

It's very good for what it is. My main piece of advice for using it, is always start with dies two sizes larger than what is needed to get the cleanest crimp. You can send it the first time with the correct size too but it doesn't look as pretty.

 

I'm planning on a similar setup - probably have 4-6 light switches and compressor / locker.

 

I made this one up to fit my Taco and then never installed it haha. So I guess I'll alter it again for the LC, gotta find a good spot.

 

What mostly assembled box did you buy?