SOLD 3 Switch Panel with Switches and Radio Harness

This switch panel replaces the useless little cubby on the lower left side of the dash on a 2016+ Tacoma, with a panel that allows 3 aftermarket switches to be hooked up. This allows 3 of the Toyota sized switches that measure 21mm x 39mm, to be installed. This one was designed by TW forum member forty2 and purchased through Shapeways.
https://www.tacomaworld.com/threads...ecause-the-thing-i-wanted-didnt-exist.415922/
https://www.shapeways.com/product/C...or-16-tacoma?optionId=59283462&li=marketplace

The 3 switches in the panel are all from www.ch4x4.com. You can connect on to an LED light bar, or any LED lights you want. The backup camera switch is wired into the radio harness so you can turn on the backup camera any time you want. The GPS switch is also wired into the radio harness and will allow you or a passenger to use all the features of the OEM navigation even while driving, since it makes the truck think that you are stopped.
https://www.ch4x4.com/product-category/push-series/toyota-push-switches/

The radio harness was from forum member jshsltr who designed this so you can splice into the wiring behind the radio for many uses, but keep the factory wiring all intact. Here is the original thread: https://www.tacomaworld.com/threads/sold.458293/

I would like to sell all of this together. The backup cam anytime switch and GPS switch are still wired into the harness, so you just have to plug it in. This is a super easy install. There are 2 wires to connect to make the LEDs in the switches illuminate, switched power, and ground, and that's it. You would connect your light bar wiring to the other switch based on your specific light bar wiring. (I also have a Cali Raised LED light bar for sale.)

Asking $100 shipped in the lower 48 states for everything pictured.

 

I'll take it PM sent thanks

 

SOLD! Thanks @flat_tire