Dome light not working

I have a 2003 Toyota Tacoma. I tried changing my dome light today to an led, after I made sure the led worked I took it back out cause I had to adjust it so it would fit a little better then put the led back in and now my dome light doesn't work I even tried a normal bulb.. Any ideas what's wrong? Also new to page first post

 

You cant just pop an LED in, they dont work unless modified.

http://www.tacomaworld.com/forum/1s...dome-light-led-bulb-actually-works-right.html

 

Check the fuse to see if you popped it.

 

My dome doesn't even work woth normal bulb now

 

Which fuse would I check

 

check your fuses, do your map lights work still? the ones by the rear view mirror.

 

x2

 

you have a fuse box under the hood over the driver side tire and one on the lower dash area by where your left knee would go.

 

It is easy to have one end of the bulb touch both the clip (12V) and the roof (ground). I did this when replacing mine. I believe I found the fuse for the dome light in the fuse box that is under the hood near the battery.

 

See this thread.

 

Mine occasionally doesnt work when the door is open.
I just give it a good slap and it comes back on.

 

Not always the case. I'm using LED bulbs in mine, without any mods.

 

Thanks for the help guys, blew the fuse replaced it now the led light works perfectly! No mods and it only lights when it's supposed to

 

Yup I blew the 7.5 fuse changing my dome bulb too. Used my jackknife to pop the old one out. Poof.