ADM and Bleeding clutch questions

So just did the accumulator delete on my 19 6mt, I think I've bled all the air out but not sure. The bleeding procedure I used was
1. Open bleeder
2. Clutch gets slowly depressed
3. Close bleeder
4. Check fluid level and repeat

It seemed like I would have a couple bleeds where there was no air but some would have a decent amount of air.

So is this a good procedure for clutch bleeding?

After successfully bleeding after ADM should the pedal feel softer on the first half of press then pressure increase on the second half? When I release it feels slow to release then pops up.

Did anybody develop a squeaking noise when pressing the clutch pedal down?

Sorry about all the questions I just wanna make sure I have have done this correctly.

 

Sounds like you still have air in the line

 

Gotta get another bottle of fluid but I'm gonna keep bleeding tomorrow.

 

here’s what I did

https://www.tacomaworld.com/threads...dm-and-bs-thread.568303/page-41#post-19760830

some tubing definitely helps too, it was like a dollar at Walmart.

 

Thanks I will try the way you did