What Have You Done To Your 3rd Gen Today?

Yes they are. I looked all over for some seat covers that I liked and finally found these ones. Did yours come with the rear seat cover and center console cover as well?? Also did yours come a little on the wet side, like the dye hadn't fully dried yet? I let mine sit out for a few days until they felt dry to the touch.

 

Thanks. I appreciate the quick reply and explanation.

 

Blue is positive

 

Just message him on instagram or email him hes a good guy. Was patient with all my questions I had last night and helped a ton! Needless to say he is building me a stealth scoop light now!

 

I got these.

https://www.amazon.com/YITAMOTOR-Un...id=1578334761&sprefix=yitamotor+eagle+&sr=8-3

I took the door panel off, speaker out, popped door sail off and removed mirrors. There are 3 black circles of tape that you remove to get to the bolts for the mirror. The plastic piece on the mirror where I put the light in just pops out. I drilled a hole, put a small amount of silicone on both sides and installed the light. Then ran the 2 wires through the mirror and through the door when replacing the mirror. I ran the wiring behind the plastic on the door to the bottom behind the speaker then through the boot from the door to the kick panel inside the truck. You can unfasten the boot and use an old wire coat hanger to tape the wires to in order to pull then through the boot with the wires that are already there. You will need to remove the kick panel in order to do this. Then remove the cover on the A pillar. I ran the wires up to the A pillar and tapped in to the blue and yellow wires. Blue was positive. I don't have many pictures of the install. Where the green circle is located is where the bolts are for the mirror and where the sail panel is located. When replacing the sail panel, MAKE SURE you remove the clips and place them on the panel, dont leave them on the door. If you do, you will push them all the way through and they will fall inside the door. I know from experience. The red arrow is where the 2 wires come in from the mirror that you run to the A pillar. You connect the wires from both the left and right mirror lights together then tap to the A pillar wires. It's not difficult, just takes patience. Let me know if you have more questions.

 

Sounds good. Do you have his email? I dont have an Instagram account. Scoop light is intriguing.

 

Here ya go!

After reading about the cheap light bars some people do not like, I have no problem paying his prices... I would rather have his customer service than some chinese dude... plus everything is plug and play and ready to go out the box, even a switch for the dead spot next to my auto hi beams.

 

L

Thanks

 

Added some bling to the front of my SR5 with these Limited fog light bezels. It is getting to be about right. . .



Also installed my Meso GassHole.

 

Wife and I had to stop after work at the ATT store so I just met her there. She and I parked next to each other (Taco and T4R on right) and within 10 minutes there was another Black T4R parked on my left.

 

Is that a drone Case on the left? We use something similar for our Matrice 210.

 

Purchased and mounted my maxtrax

 

Cool ant ty. I’m going to look into doing something like this. Thanks again

 

I figured for essentially a BOGO why not just dive in? Totally worth it.

I read through that thread multiple times and exchanged some DMs. For the simple use I needed these for, I highly recommend them already.

Now about my fogs...

 

Mine came with the rear seat covers and the center console cover but did not use it as I already had a console cover...

They didn't seem wet or damp to me...

I had a few extra patches sewn on my headrest covers by a lady at church (patches also from ebay)...I'll try to post pics sometime

 

it was pokey1416’s pic.... I just turned it off it’s side.

 

Amazon of course

$70 AGENCY 6 Recovery Shackle Block Assembly 2" Double Hole Powder Coat Grey - Hitch Receiver Block - Proudly Made in The USA with US Certified Materials - Includes Hitch pin and D-Ring

https://www.amazon.com/Agency-Recovery-Shackle-Assembly-Double/dp/B07R113W8M

 

These came in the mail today. My wife asked what kind of kinky s#!+ I was into

 

No problem. It's very cheap and just takes a little time. Paid 10 bucks for the lights and had extra wiring. Had no other cost involved. Love mine and glad I did it. Good luck with your decision.

 

Haha...you got me laughing out loud when I read that...thanks!