HELP 1996 tacoma 2.4l NO power to crankshaft sensor

Hey there people! I have no power to my crankshaft sensor. I have ground, I've changed the sensor. I have an aftermarket sensor and two original sensors. All my relays ar working. I've changed the computer. Only option I have left is my harness my have a pinch or a short circuit. Or I dont know if my distributor my be giving the correct voltage. How can I fix this?

 

What is the issue? Cranks but does not start? Does not crank?
Back up a little bit and tell us what is happening.

 

Sorry going to fast. Yes starts but turns off after the first 7 seconds. Will stay on if I give it some gas for a minute. But with out that it turns off.

 

I hope this helps.




I would check on either side of the splice for continuity.

 

This started with A PO335?

When the ECM does not see the crank Signal it shuts off the fuel.

You have changed so much rather then trouble shoot the real problem.

Have any new codes tripped since the adventure started ?

So easy with all this unplugging and plugging to bend a pin causing a open circuit .

A short circuit leads to open Circuit protection or at worst a Visit from the Fire Company.

Best of luck

 

No it's the only code that keeps pooping up. I sis look for any pins the may be ben but everything looks good. I changed the computer and it gave power for the first start. Second start once again it tripped the code.