HELP Wheels that will fit 1986 1 ton pickup

The stock wheels that I have are marked 5.5JX14 3885/12. I'm looking to get 15" steelies so I can put on all terrain tires. I got some 15" steel wheels off of an avalon from the junkyard and they do not fit due to the wheel hub bore being bigger. Suggestions for wheels would be appreciated.

 

It looks like they did offer a 15" wheel for those older trucks but you need the 5 x 114.3 lug pattern and at least the 67.1 mm center bore. Most of the Toyota cars have a smaller bore or they have a different 5 x 150 pattern. The Tacoma 5 lug shows as 5 x 114.3 pattern but the center bore is 60.1 mm which is too small. It looks like a hard wheel to find the 15" with the 5 x 114.3 pattern.

 

Thanks, I’ll probably just have to stick with what I’ve got then.

 

@JL8Jeff I just found these wheels, it has the same lug pattern and center bore, would these work? I’m not sure about the other numbers.

https://www.amazon.com/dp/B01M7U455J/ref=cm_sw_r_cp_api_glt_fabc_YWKCBGYNE4FSPSXVWNDV

 

The lug pattern and center bore look ok, but they are showing a +45 offset where the stock wheels are +20 offset so I think they will be too far in and not clear some of the steering components. When you do the "Check fit" on Amazon, they come back as not fitting.

The stock information shows the offset of +20 (it shows as ET20).

 

You have pre 87 1T rear axle and its 5 lug? Its been a few years since I last worked on one but AFAIk 86 and older 5 lug 1T axles had issues when loaded heavy and snapping the axle and loosing the wheel as they arent true full float. In 87 Toyota fixed it and went full float and 6 lug.

edit
http://toyotacampersforsale.com/toyota_motorhome_axle_facts/Axle_FAQ.pdf

https://toyotamotorhome.org/forums/index.php?/topic/1132-18-axles-do-fail-replace-yours-asap/

 

After looking around, the closest wheels I could find would be from the Mazda B series trucks from around 2001. They have the 5x114.3 pattern and a 70.6mm center bore where the Toyota pickup is 67.1mm center bore. The offsets are around 10 to 12 mm compared to the Toyota being 20mm so it would push the wheel out a little. Since the bore doesn't match exactly, you could put in some centering rings like these.

(1) Hub Rings 67.1 MM To Many Sizes In Aluminum Set of 4 Pcs Hub Centric – Venum Wheel Accessories

Here's the page showing the Mazda specs and they use the same size lug nuts as well.