Bumpstops that work with uBolt Flip kit?

Put on a u bolt flip and looking for some aftermarket bumpstops (2021 Tacoma) that's compatible with the supreme suspensions u bolt flip kit(part #71160). Currently running nothing

 

Looks like durobumps might work. Can't confirm without hole dimensions though.

https://durobumps.com/3rd-gen-tacoma-rear-bump-stops-3-5-2016/

 

Wheelers super bumps seem like they should work.

 

Doubtful durobumps would work without drilling holes to run the securing bolts through. Not a big deal, just probably not "plug and play"

 

Agreed. However it looks like his flip plates have the holes... so if they're properly spaced or sized, it could work... OR, they could hinder drilling proper holes, as you suggested.

If OP has the plates and can measure the hole spacing/sizes, I can try to measure my Duros.

 

I climbed in the wheel well so you don't have to haha. It's 2.5" c to c and they're designed to run front to back to clear the u-bolts, but might not matter

 

Hmmm... something about that photo looks familiar.

 

These might, if you can find someone that has them and can measure the hole space- https://www.superspringsinternational.com/shop/ssr-611-40/

they are also having a 15% off sale. The fronts are pretty good to have too- https://www.tacomaworld.com/threads/front-sumos-super-thread.733949/

 

Hey y'all! Thanks so much for the feedback. Here's the measurements on my flip plate. Looks like it may not be able to fit those duros https://imgur.com/a/yACLpm6

A side question, how bad would it be to have the top of the U bolts act as bumpstops?

 

Sure it would, if you drilled 2 holes

 

I’m running the archive garage u bolt flip kit with king hydro bumps been working great

 

At that point, I'd just super glue/drill my factory bumpstops in. 'twas hoping for something OEM to the plate

 

Actually, what If I just JB Welded my factory/aftermarket bumpstops in? My only concern is needing access to that center nut but I'm pretty sure you just take the plate off at that point anyways right?

 

Timbren, bought the "Flip kit bump stop" from Wheelers.

 

Very bad idea!

 

Gotcha, what about extreme tape/ JB Welding my factory stops to the plate? Doesnt look like I need access to that middle hole since it's just the center nut for the leafpack and I'd just take the whole plate off at that point if I had to get to it

 

I mean... it will probably work until it doesn't. I personally would look into aftermarket options, since the OEM bumps are as hard as a rock.

 

Yeah, just thinking that since it seems the aftermarket options will require modification with the plate I got, too. I dont really mind hard bumpstops as long as they do the job. I'm not trying to prerun in baja with a Tacoma, so the bumpstops are just there to not blow out my shocks or bend something while im wheeling

Think this'll work for my use?

 

Off topic here. Are you reading the wrong side of the tape measure? Looks to read about 2.5 tenths of a foot (or 3")?

 

Top side is inches, bottom side is tenths. Odd angle, actual measurement is 2 11/16