What Have You Done To Your 2nd Gen Tacoma Today?

Jealous, I almost grabbed a red runner to match my taco. Maybe one day...

 

Is this the one from Georgia that had a $13.5k asking price.

 

Tore this POS out before I do the ADD delete. Wanted to see what the issue was while I wait for parts. Not much water but seems there’s been enough for a lot of corrosion to occur on the motor’s terminals

 

Where did you grab these?

 

Correct. Are you familiar with the truck?

 

Awesome truck!!!

 

No I have the x-runner on my iseecars.com search list so I remembered the color and wheels on that one. Would love to find one with the supercharger.

 

Same here, passenger and driver. ToyTech springs installed originally in 2017. Replaced with a used Rancho set-up.

 

Added some courtesy lights, used some wood brackets from home depot and tapped into the dome light circuit

 

I keep an eye on JDPower, this one wasn't listed there though. I think I saw it on Cargurus. A S/C one would be amazing.

 

This looks great! I bought these a month ago and was wondering how I would get them attached. Going to steal your idea.

 

Might have to steal this idea too!

 

Had 'em made. I stuff them in as freebies for folks buying 1GR-FE wiring kits.

 

I tried (or am trying) to installed a Cali Raised molle panel on the left side of the bed. I watched their instructional video several times then had at it.

But as you (hopefully) see in the pic, the panel sticks out about an inch on the bottom compared to the top. I would have thought the panels would be vertically parallel with the inside of the bed.

Is this normal? Is this what it is supposed to look like? (See bottom of picture). #MeNoHappy #NoBueno

 

It looks bent to be honest. I've had a set of those on my old truck. You can bend them kind of easy actually

 

The three tabs along to top of the molle panel are bent slightly; it looks like they were designed that way. I'm half-tempted to use some kind of a bolt to attach the lower tabs to the bed.

Do you think a Rivet-Nut would work on the composite bed?

 

Maybe that would hold. I bet the sheet rock butterfly bolts would work

 

Like these

TCH Hardware 10 Pack Toggle Bolt 3/16" x 2" + 4" Slotted Drive Screws - Drywall Sheet Rock Anchor Hollow Wall Butterfly Spring Loaded Wing

https://www.amazon.com/TCH-Hardware-Toggle-Slotted-Screws/dp/B07CHVJJYS

 

Out of curiosity, have you tried swapping the panel to the other side, so the bend in the tab forces the bottom of the panel into the truck vs away?