Mid Travel BS 2.0

I thought you meant the lower bolt.


Just got one side welded in. Forgot the resi mount, but thats not too hard after the fact. Dont judge my welds. They're not pretty, but they're strong

 

Hmm

 

you can see all the rubbing

 

And do you have a spacer?

 

Midtravel life, managed to blow out 2 inner tie rods, bend both gusseted spindles and uca bolts last weekend half assed fixed those and pretty much did the same today. Steering rack is now donzo as well

 

If anyone is in the market for a mid travel setup, I’ve got one for sale on here. Just needs a rebuild.

 

I have a set of 3/4" spacers if you want to come by and try them out.

 

hey, you’re putting in the work and welding is an obtained skill. I applaud your efforts. It should work out just fine even if they aren’t pretty.

 

Do you have a rotatable body cap and why not just move the resi a bit?

 

i rotated it as far as I could. Compression tube is a just cunt hair off the frame.

 

The other side will be better.

yes I would like to do that. Thanks!

 

Flip the bypasses to the other side and turned around. That tune will nest inside. I had the same issue and went away after that. But not after it spun the adjuster off.

 

Orientate them like this and you’ll be good.

 

I halve 3.5 BS if not you need to run a spacer but biggest even then I had rubbing and flipping shocks around was clutch. posted that photo but no longer have it on. Went to a +2 kit. Need to post it up for sale.

 

Saved for the future.

Im sore from working on this for 5+ hours yesterday. I will resume soon. Sucks getting old and no lift haha.

 

Bro it’s brutal.. did it in middle of texas summer.. terrible

 

I hear ya. Recently re did the front end and I just had someone else do it this time. as much as I wanted to no time and tired not so easy In the Driveway. Picked up a welder but haven’t had time to learn. props for tackling it.

 

Shoutout to Total Chaos!

 

Has anyone found that their coilovers soften up significantly once "broken in"? I installed Kings this past winter and admittedly didn't get off pavement until just recently. Now I've been hammering some forest service roads and seems that the suspension feels much more juicy than it did a few months back. Not necessarily a bad thing, I can close the compression to compensate.

 

Welds looking a bit better today. Although I tried a different side shock, and it didn't look like it would fit without rubbing. I did not test fit the wheel this time. Only need to burn in one more thing and then it will be mounted to the frame. May even have time to call @TOTAL CHAOS and ask for some advice..

@cdex8357 its 89 (high of 92) and 58% humidity in VA today.. i seem to pick the right days to do outside work with no shade.

Damn my 1 car garage townhouse that doesn't fit anything!