Remote Tailgate Lock - TRD OR '22 DCSB

Hi All,
Wanted to confirm if this remote tailgate lock works specifically with the '22 TRD OR DCSB.


Not sure why but all the Toyota parts sites say it doesn't fit:



Just wanted to double check before I pulled the trigger on the purchase. Thanks for the help.

 

That’s the part number I have.
I’m removing mine if you want it.

 

The other PN is for DCLB

$159 PK3B6-35JL0 Toyota Genuine 2019 & Newer Tacoma Long Wheelbase Tailgate Lock PK3B6-35JL0

PK3B6-35JL0

 

I have the same kit. It should fit. Just make sure its for the DCSB and not the DBLB.

 

S and L specifies the difference

 

thanks was just researching this tonight and running into the same brick wall. I installed on my 21 SR5, but picking up a TRD off road 22' and was wondering if its the same install process, plug and play? thanks.

Update: can confirm the remote tailgate lock kit OEM works for the 22 off road model plug and play!

 

Curious why you're removing it. It was the first thing I did to my truck and I added an interrupt switch/valet switch so I could lock stuff back there without giving access to people who don't have the tailgate key.

 

Thats it and yes, its plug n play. Takes about an hour. Zip ties underneath being the most time consuming part.
Game changer mod. No more fumbling around with the key in the dark.

 

I ended up keeping the lock there when I sold the Tacoma. This mod was my first on all my 3rd Gens. I hated using the key.

 

Still need to pull the trigger on purchasing the remote lock but from what I've seen it should work out.

 

Update on my end. Can also confirm that the Toyota Part #

$160 PK3B6-35JS0 Toyota Genuine 2019 & Newer Tacoma Short Wheelbase Tailgate Lock (PK3B6-35JS0)

PK3B6-35JS0 will fit on 2022 OR DCSB. Put it on yesterday. Install was about 1.5-2 hours. So far so good!

 

Thank you for confirming. That is my next upgrade followed by a cat shield. Gotta love living in Cali.

 

$160 PK3B6-35JS0 Toyota Genuine 2019 & Newer Tacoma Short Wheelbase Tailgate Lock (PK3B6-35JS0)

PK3B6-35JS0 fit on my 2022 OR 4X4 DCSB as well, all thanks to this thread.

A question... during install, of the clip in the tailgate that helps hold the actuator's wire in place, did any of you use the 3M Autobody Sealant [08302] as shown in the installation directions? Thanks.

 

I did not and 2 years later, I dont have any issues. Probably my favorite addition to the truck.

Unrelated, but one issue I ran into during my installation is that the LED under car puddle lights used the floorboard cutout and I could not squeeze the pop lock harness through the gasket. I had to use another cutout that was further back and more central, somewhat need the middle rear seat where the feet are. It was a pain but I made it work.

So just an FYI for those who have the LED under car puddle light accessory, you may run into some complications.

 

@nucl3ar Thanks. I went with a bit more of a bootleg, "this won't rust but I hope it lasts," route.

 

Very clean! Creative idea as well. I may have to open mine up and copy you haha.