Borla Y-Pipe

Anyone have any experience with this and how do u like it?https://www.extremeterrain.com/borla-tacoma-y-pipe-60699.html

 

I was looking at URD at one point, but ended up getting a Cat shield. You might find some useful info on this link to help you compare.

https://www.tacomaworld.com/threads/urd-mark-2-y-pipe-v6.674232/

 

I just installed one of these. I chose this over the URD as I do not care for the noise they produce, and over the AFE because that doesn't actually reroute the exhaust and still hangs under the frame. Overall the Borla is a pretty nice y-pipe and I would recommend but it's not without its issues. Hopefully the following info can help someone looking into this system.

The good: It's beautifully built and looks fantastic, comes with all necessary heat shields and makes the truck sound a little throatier giving it a tone more similar to the 4.0l on accel (mine's paired with the MF Overland catback), but seems a little quieter on the highway.

The bad: Their instructions say to reuse the stock donut gasket between the y-pipe and catback, but the 60mm stock gasket does not fit on their 62mm piping, so I had to source a replacement. The passenger side of the piping would allow for perfect fitment if it were about 1/2" longer.

Post from my build thread here: https://www.tacomaworld.com/threads/drizzohs-21-off-road-build.748190/page-8#post-28349851

Stock vs Borla:



Gasket needed:
Mahle 60512
ID: 62 mm (2.44 inches)
OD: 78 mm (3.07 inches)
Thickness: 5 mm



Installed: