windshield leaking

Need help from windshield installer or Toyota Techs. I washed the rig today and there is a leak into the cabin air filter (Pic 1). I've cleaned the wiper gutters, etc. I noticed the window seal on the passenger side to be bowed away from the windshield (pics 2 and 3, yellow circles). It is not tight against the windshield like on the drivers side.

Before I tear everything apart, is there a schematic of the windshield and gutter/seal? Are there clips that hold the seal/gutter? other than siliconing the crap out of it, is there a way to fix this? New gutter/seal or take to a windshield place? It was replaced a year or so ago.

Many thanks!! KB

 

I took the “cowl” off to do a different thing.
But to answer your question.

Instructions thanks to @dpele
Q: Are there clips that hold the seal/gutter?
A: Yes, it is at the bottom. Not where the windshield line is.

Q: isthere a schematic of the windshield and gutter/seal?
A: Yes, if you wish to remove the Cowl.
Lift up the hood.
Remove Windshield arm from motor. I think it’s a 14mm socket.
Disconnect the push pins on either side and along the entire length of the cowl.
Tip: mark your windshield wiper arms with tape, to make re-install easier.

Q:New gutter/seal or take to a windshield place?
A: Probably I think it’s an entire unit.
I can’t answer as I don’t recall.

 

That seal doesn’t “seal” water out.
It only slows the water down. There is a drip channel under the cowl. It’s directly over the cabin air intake. If the channel gets blocked with debris, it can allow water to over flow into the cabin air intake.

It happen to me.

See the link below for more pictures.
https://www.tacomaworld.com/threads/water-thru-cabin-air-intake-my-solution.88655/