? Torque specs for FRONT SUSPENSION MEMBER Brace Sub-Assy on Gen2 single cab

Hi all
I am having to replace both of these items on relatives Gen2 Taco, (it is the single cab from '11)
and wanted to know if anybody might have the specific Torque Specs for the 7 or 8 bolts that secure this piece, 51404A and 51403A in the diagram below

part# - 51404-04020
part# - 51403-04020





thankYou

 

https://www.tacomaworld.com/threads/the-torque-spec-guide.318116/

 

ThankYou

i gave that long list a once-through and got close to the item of concern but did not quite find it or am i overlooking it

it is in this general area, but its part of the frame, which i did not find the first time through

is there a 'Body' section in that manual with the specs?

 

For These braces
7 bolts

 

The bolts...

 

They are 17mm

 

At 45 Nm those should not be on too tight to break the old bolts free with a 1/2" breaker
Will see how it all goes...

 

no breaker bar was needed!
just a 1/2 heavy-handle ratchet from tekTon + small extension with the 17mm

successfully completed this fix in about 4 hours in the 90 degree heat on the driveway
took my time did not force anything... bummed shoulder sucked that never wants to heal

the 2 middle bolts (whose ends are exposed to the elements) gave the most struggle to remove as the whole thread lengths were crusted from the decade+ of winter salt exposure
new bolts went in LIKE melted BUTTER
coated them + the welded nuts on the new braces very well with the WoolWax HV sheepfat so no roadsalts will EVER touch them again and rott those nuts off or screw up the threads

45 to 50 Nm is Fairly close to a German Torque Spec LMAO