Check Engine light help

I was driving the other day and my check engine light came on, my ultra gauge told me that it was p0101 basically the mass air flow sensor so i took it out cleaned it and replaced the O-ring as it had broken so that was the problem. I cleared the code and went on and all was good, so today while driving my ABS light and limited slip light come on at the same time, then 20 miles later my check engine light also turned on. The ultra gauge is currrently not able to read the check engine light but i did do the the jump wire trick to try and figure out the code. For the check engine light it flashes three consecutive times, pauses then flashes once. Im not sure what code that is, and for the ABS it just stays lit and doesnt flash so i dont know which code is making it go off. I cant simply just drive to the dealer because im in Germany, any help from you guys would definitely help.


Thanks

Truck is a 2011 sport DCSB with 41100

 

Abs, vsc will come on with a cel, p0031 is bank 1 af sensor heater circuit low voltage

 

^^ Nice.

 

followed the steps in the following link and so far everything is working good, i just unplugged the relay then plugged it back in and all is good


http://www.tacomaworld.com/forum/2nd-gen-tacomas/89436-p0031-p0051-fix.html