1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

07 Reg Cab Seat Swap

Discussion in '2nd Gen. Tacomas (2005-2015)' started by JohnnyD, Jul 11, 2008.

  1. Jul 11, 2008 at 6:42 PM
    #1
    JohnnyD

    JohnnyD [OP] New Member

    Joined:
    Jul 11, 2008
    Member:
    #7880
    Messages:
    3
    Vehicle:
    07 reg cab
    I really need some help. I have managed to get hold on 2 bucket seats from an 06 Tacoma. Am not sure what model. But I have ran into a few probelms. The connector on the wiring harness for the passenger seat doesn't mate up and the seat belt buckles does not fit the latches. Any suggestions?
     
  2. Jul 11, 2008 at 10:21 PM
    #2
    Synapse

    Synapse Well-Known Member

    Joined:
    Apr 18, 2008
    Member:
    #6059
    Messages:
    93
    Birmingham
    Vehicle:
    2008 Tacoma
  3. Nov 12, 2008 at 4:44 PM
    #3
    Coheednme13

    Coheednme13 Well-Known Member

    Joined:
    Jan 9, 2008
    Member:
    #4172
    Messages:
    244
    First Name:
    MattDaddy
    Elgin, SC
    Vehicle:
    11 DC TRD Sport
    any luck with this?
     
  4. Nov 13, 2008 at 9:39 AM
    #4
    Coheednme13

    Coheednme13 Well-Known Member

    Joined:
    Jan 9, 2008
    Member:
    #4172
    Messages:
    244
    First Name:
    MattDaddy
    Elgin, SC
    Vehicle:
    11 DC TRD Sport
    just wondering if you could take a pic of the connectors underneath the seat. I am going to try this swap. This is how I am going to try to address these issues.

    1. Either: a)swith the male buckel to one from a double cab by removing the plastic peices that keep the buckle form falling and trying to replace it

    b)get the whole seatbelt setup from a double or access cab from junk yard that I got the seats from

    2. for the wiring i will see if there is a different connector that serves the same purpose and rewire for the new connector or just see if leaving it disconnected means that the airbag is constantly on and not just when a sufficient load is in the seat.
     
  5. Nov 18, 2008 at 5:06 PM
    #5
    JohnnyD

    JohnnyD [OP] New Member

    Joined:
    Jul 11, 2008
    Member:
    #7880
    Messages:
    3
    Vehicle:
    07 reg cab
    No, I have not had any luck with this. Other project have taken a priorty. If you figure something out, I would love to know. I have the seats but have not switched them out as yet.
     
To Top