1. Welcome to Tacoma World!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tacoma discussion topics
    • Communicate privately with other Tacoma owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

110w/400w converter mod problem HELP

Discussion in '2nd Gen. Tacomas (2005-2015)' started by Goshawk, Apr 30, 2012.

  1. Apr 30, 2012 at 1:57 PM
    #1
    Goshawk

    Goshawk [OP] Well-Known Member

    Joined:
    Apr 30, 2008
    Member:
    #6310
    Messages:
    50
    Klamath Falls,Oregon
    Vehicle:
    SR5 Tacoma TRD 4x4
    K&N cold air intake. 5000lb Air Springs
    Ok I did the converter mod today BUT it appears to only work on the 100w side. Meaning the 100w light ONLY comes on. Below is what I did and if I screwed it up somewhere help would certainly be appreciated. This was done on a manuel 6 speed.
    #1 cut violet wire/ white stripe and capped both ends
    #2 cut blue wire blck stripe and ran power to the CONNECTOR side from fuse block. Capped other side.
    #3 tapped into the red wire white stripe and ran that to the large spade side of outlet.
    #4 tapped into the light green wire and ran that to the small spade side of outlet.
    #5 tapped into the white wire black stripe and ran that to my ground side of outlet.

    Again any help would be appreciated, thanks Ron.
     
To Top