1st Gen Lunchtable Thread - General Discussion

Evil

 

Oh and peaking through the intake hole, piston looks beautiful!

 

You know Rick Rolling is a bannable offense on this site lol

 

I can there not as bad as huskies

 

Oh yessss I wanted to use one baaaaad when I did the fronts on our two
For real I wanted to, I bet it makes greasing that bushing, and just getting fresh grease in there, so nice. That's an important bushing to make sure stays greased in the 80 series as well.

 

I'm sure standards would change if they saw your legs

 

The husky I had lived indoors as well...

 

Same here, I'm looking around thinking did he just rick roll us???

 

Ooooook

 

Oh yes.. Got to keep that brass bushing lubed. I'm leaning a lot about wheel bearings this summer.

 

What's wrong with my legs

 

#INB4THELOCK

 

I dunno man, sounds like you're screwed

 

Man screw that guy! Just buy em! If their wrong send em back, so what if there's return shipping

 

Bad enough that your ass is on fire way before you get to the cheese grater, provided that its hot outside.

Seriously, whoever thought reflector slides were a good idea mustve enjoyed the pain of burning flesh.

 

Stuff designed to be rebuildable/serviceable is my fetish
I replaced the front wheel bearings on my hundy about 6 months after I got it. I didn't catch it quick enough to just be able to service them and be good. My mpg started dropping and investigating that led me to find the wheel bearing play and Bob's your uncle. MPGs back to normal and ride as well. Had to have been close to 200k miles on them and the 100 series is one heavy pig too

 

The plastic slides weren't much better, get to the end and touch the sides and ZAP

 

Anyone know the ft lb trq on those 2 bolts ive been talking about? Like can i expect the fkrs to back out again if i got em snugged decent? The one in front was at a bad angle, socket kept slipping and i was roasting my hand on the heat shield loool