1st Gen Lunchtable Thread - General Discussion

I stole that from you.... I should've given credit where credit is due

 

Idk its just spinning now. Wont tighten or loosen. Gonna go to vatozone to get those plyers and a new plug

 

There is no hex?

To me it looks like it snapped at the same spot as the discoloration on this one:

 

Pray to god not. Idk how imma get it out if so

 

Oh suck.... If that's what happened, wtf man? How the hell would you get that out

 

Is the other part in the coil boot?

 

no everything is still in place still inside of their it's just spinning freely and won't detach so I'm hoping that there's just oil cooked on there right now. I should change this ignition coil and the spark plug correct? Possibly a bad ignition coil cause this issue with the plug correct? just such a mess LOL

 

Yeah, if oil is getting in there and cooking into the threads as the oil drops down there, you just want to make sure the oil got there from like pouring oil into the engine or similar. A chance it could be the spark plug tube seal things.

 

Looks like the plug didn’t seal and hella oil escsped

 

Good Fn luck.

 

@cruiserguy https://www.instagram.com/p/CC0_SJEJDlR/?igshid=1bux1984bma1o

 

@Wulf https://www.instagram.com/p/CCzEBRUhS9M/?igshid=1ob65znkepn3p

 

If you have a long pick I'd try and get it under the hex of the spark plugs and put some light pulling pressure on it while backing it off

 

I wonder they make spark plug pliers long enough to each down and grab It

 

Approach angle for dayzzzzzzz

 

@Tour991

 

I did vinyls for my buddy's Tercel gambler: "the green latrine"

 

@Wulf and tim gunna fight over exhust?

 

Yes, change both once you get it out.

Try soaking it in PBBlaster. Just spray some down the hole and let it sit for a little while. Then take a flat blade screw driver and see if you can loosen some of that crap and suck it out with a shop vac. Any PBBlaster that gets in the combustion chamber will just burn up when the engine runs.