1st Gen Lunchtable Thread - General Discussion

I knew you liked balls in your mouth

 

Now just fill the reservoir and crank it back and forth a couple times with it off and then again with it on?

 

Moab is leaking.







Ewww.

 

Yeah that shit just rubbed me wrong.

I have an open door policy; employees are welcome to come to talk to me about anything going on, etc.

I'm that guy that prefers to have a one on one with employees, no formal write ups (unless it's absolutely necessary), etc. I understand life gets in the way, or maybe you flat out made a mistake. But don't lie to me.

 

There will be a coffee table book one day, mature audiences only

 

From the sound of it, it'll be a pop-up book.

 

I just get excited sometimes...

 

Yeah I don't get that either, especially if you've never given them reason to think you'd be unfair or something. Some people are just programmed to lie or embellish stories though it seems

 

If anything it should be close. Once it’s back on the dyno, I should be able to check it with theirs. I also have the UltraGauge but I don’t know how much it can be trusted since I believe, the sensor it’s running off is a narrow band. Sensor in the first cat.

 

Accurate?

 

Nah man, your bus was waaaay shorter

 

Don't talk about yourself like that.

 

No tennis yourself

 

I did talk to text and it went retarded

 

You two have so much in common

 

Yeah, basically crank the wheel back and forth until the level stops going down a lot and then you can start running it and bleeding under pressure

 

Done


No more arm day whenever I drive

 

My OME890 coils arrived; they'll be used once my dual swing out rear bumper is completed.

Interesting to see the box is different than the set my OME906 coils arrived in.

 

Must've gotten to their new stock, they stopped doing the full picture dirty spring thing