1st Gen Lunchtable Thread - General Discussion

Just needs some:

 

Ive always wanted models of a C&O Allegheny or N&W Y6B. Freakin beasts of machinery.

 

I'm getting this one

 

sharing a calendar together is such a good move

 

Honestly I would get in a ton of trouble for forgetting shit otherwise, it's the best thing since writing reminders on the inside of my hand

 

Shit I was supposed to order more diapers

 

@BartMaster1234

Teach me how the faq you get pins out of a connectorer

 

Yeah just sucks because if I could go back to 2017 I wouldn’t have applied to go to college. Feels like I’ve wasted so much time and money. Could’ve been making money by now. But I’ll figure something out.

 

They usually pop out after cussing at them a lot. And a small pick to push em out.

 

I really really hate working with fiberglass

Queue @BartMaster1234 for the breaking bad memes

 

Lmaooo good luck. I have a special depinning set specifically for Asian connectors.

That connector may or may not have a retention slide you need to release on the lateral side of each connector. If you have fine point eyeglass screwdrivers, you can lift the plastic latch holding the pin into the housing trough the top or bottom. Really just takes practice.

 

is this you?

 

Ok, you're definitely not riding shotgun in the 4R









































































































You're riding center console

 

I’ll find something to pick poke with, there’s this plate thing on the bottom too?

 

I usually try with a pick until the connector disassembles itself

 

OH yeah. Monsters. UP 4014 came through KC in 2019 so a buddy and I chased it a little bit. I'll never forget that sound, should dig out the video.

 

Or just cut and replace with a new molex connector off Amazon.

 

Yeah that’s the retention slide I was talking about. Lift it up and it stays in place. Don’t use a pick to de pin the connector. Use the smallest and finest flathead screwdriver you can find. Eyeglass ones will work

 

Can you tell me if these have heat or nah?

what wire?

 

Dear lord no.... more like these guys