1st Gen Lunchtable Thread - General Discussion

Then slap that old needle in and give it a test fire. Or wait till tomorrow. If you can't feel a ridge with your finger then the chance of it leaking past is very low. Double checking if you see a ridge will tell you if it'll wear out sooner rather than later. Regardless it was still subject to the old nasty gas so it's smart to change it.

But my own personal experience says you're good for next season if you need it

 

@Empty_Lord

does Toyota sell the “big 3” wiring harness for the 3.4?

I think I’ve found is the 2.7


I also don’t really know what I’m looking for

 

Used this outfit when building my RTMR. Excellent vendor, quality products. Could use them for wiring.

https://ceautoelectricsupply.com/car-audio-products/big-3-upgrade-kits/

This will at least give you some ideas. Easy enough to do your own 'kit'

 

Valid point regardless of the ninja edit

 

I’ll try it out tomorrow. Although I’m gonna complain to the company and say they sent me the wrong kit. I ordered the one ya told me to get, which all worked great till we got to the needle haha

 

I was hoping autozone sold the whole harness so I could buy it and make @Abeyancer go pick it up so he could have some measurements

 

That is fuckin dedication to laziness my friend @Kwikvette can't miss out on this getting buried

 

There’s a dead 4R down the road ima see if they’ll let me steal shit out of tomorrow.

Put it in a box and send it to you

 

@JKO1998 I don't know why your Google skills failed you, there's alot of write ups on TW even

1.battery (+) to alternator main power wire
2. battery (-) to frame ground
3. engine block to body ground (located on the back of the motor between the firewall and the block)


But no accepted lengths as far as I see

 

That's the kinda shady shit that gets me up in the morning

 

I mean I would talk to the owner haha

 

That's why it's shady, not illegal.

 

I needa look at my engine bay tomorrow and see what’s even going on.

 

@BartMaster1234


You’re doing it all wrong

https://www.instagram.com/p/CL5E8CXpz2e/?igshid=gnmwuboede9h

 

Well at least now you know what I need. For the 2.7 I gotta make the engine to body cable long for proper slack given its closeness. Account for slack

 

Much Approved of this Improvement

 

If just replacing the battery terminal ends is an option I’ll probably just do that till some makes me a harness.

my positive end is messed

 

Such a tough call to make... if the monies that good I'd suck it up for awhile. But that usually only lasts 2 years for me, tops

 

I planned on ordering and including top post battery terminals at the ends of my cables because then I can verify their amp rating from a reputable source. I'm sure the Toyotas are fine but if I can get dealer cost (not sure what that is yet) why the hell not?

 

Someone just needa getchu a V6 harness