1st Gen Lunchtable Thread - General Discussion

Epoxy top is another option other than glass.

 

You'd best be served by swaping everything from the truck the motors going in bit it will all go on

 

Oh dang, I didn't realize you were getting new construction. That's pretty awesome.

 

Any 5VZE block should be compatible. I went the other way and put an 02 engine with electric throttle body into my 96.

I had to use my upper and lower intake plenums with the traditional throttle body and exhaust manifolds to line up with the cat but everything else went ok that I can remember. If you're going with an older motor I would swap your injectors in as well.

 

Thank God I'm getting these on soon. Last time I do wheels during the summer

 

Why'd you have to sand em again, thought you never even mounted em

 

Did a recoat on em last week for the final coat before mounting and had this one run on me. Fuckin heat making me delusional working in it haha

 

sorry to hear you have the runs, great excuse to call in sick

 

It's a shit show for sure

 

My next career is going to be electronics recycling. I can't think of anything more therapeutic than spending all day running computers through a shredder.

 

https://media.giphy.com/media/3tK7DEMGN6jewLa6aL/giphy.gif

If you're in a high-tech area it could be pretty lucrative

at my last gig they would hire a mobile shredder to come. Whole desktops and laptops got tossed in because it was easier data security and tax wise than resale or donation...

 

I might have to write this one down, its less crazy than I first thought


I wonder how practical it would be to do it while living out of a van...

 

Anyone in here had luck with a cell phone signal booster for Verizon 4/5G? The big shop I work on cars at with my friends has unusable signal if the bay doors aren't open (unwise in 90+ heat).

 

Can't just use Wifi calling ?

 

Not for Verizon, but for AT&T, STRATA and Sprint.

good enough service to WFH in the middle of no where

 

Not if there's no WiFi to be had

 

Much cleaner. Thanks to the flap wheel, time to attempt massaging

 

Hard to tell from photos but got it shoved back aways and that's where I'll leave it for now. Still want to flex seal the spot after final smacking

 

Now I need a set of pliers to straighten out that tab lol