1st Gen Lunchtable Thread - General Discussion

Quebec

 

I may get one of these snorkels installed tomorrow.

 

@Kwikvette ... trigger warning?


https://www.reddit.com/r/interestin.../the_tarantula_hawk_is_so_skilled_at_hunting/

@eon_blue ...vindication?

 

Bold man cutting into a LC fender... but not let the Mud hear about this

 

I've seen those; bad fuckers

 

@Speedytech7
@Abeyancer

If Dan switched his trade

https://www.instagram.com/reel/CRCdfqnHepP/

 

So this local Root Beer is delicious

 

@Kwikvette too... Hmmm definitely seen one of them before, glad I wasn't on a motorcycle

 

Tie a piece of string to a lug and use that as a guide for a line with a grinder

 

You would want that to be done off the center of the hub… a lug would be a wee bit off

 

Not if the lug is at the top or bottom of the hubs rotation

a tad high or low but you could get it centered

 

Because it's a truck motor that's just adequate?

 

I’ll take a uz over any other v8 for a daily.
The entire UZ family is just indestructible if you don’t boost them and change the t belts

They can make big power too but they take big bucks due to the lack of aftermarket

 

Why waste money on a new Tacoma when you could have this

 

Take that on the trail and just plow all the obstacles out of your way

 

Compression restore bumped my truck from 90 to 120 psi of compression... While still not great it was a noticeable improvement

 

That's actually quite considerable, should be able to feel that. Is that the goofy grey bottle of shiny junk they sell at Wally world? I've always figured the oil filter would eat most of that up

 

Yessir

Used it on my old Camry and though I felt something but never compression checked it

Like you said, I wonder if its all in the filter by now

 

CA is going to start testing for aftermarket ECU tunes during each smog test, sucks for the 3rd gen OVT guys