1st Gen Lunchtable Thread - General Discussion

Corolla wheel bearing was the icing on my cake yesterday. Wasn't hard but annoying that I had to do it short notice... The 12t press was ready to explode, I had to use the jack handle on the lever and hid behind stuff for fear of explosion.

 

2011 Nissan Frontier SV
https://cars.ksl.com/listing/7747557

 

It's too good for it really

 

You could have probably put a JY one in for the same price

 

It was $85 all said and done. Bearing was $39 and hub was $46. The junkyard had a whole spindle with bearing but the bearing was likely as questionable and I didn't have time to get to the JY before it closed yesterday to pull it. I guess the cost wasn't so bad, feels nice now and won't need to be touched for a while.

 

Way too close to home here

 

just joking that all in you could have probably spent the same on a used one that wasn't shiny ... I'd have gone new too

 

It's 11:07 which is basically 12 so you'd best wait to send that important email til you get back from lunch at 12:45

 

Now I need a 33" spare...

 

Having a proper spare is the best way to ensure you'll never need it

Bad luck always seems to strike when no spare haha

 

Tis true, the only time I needed a full size spare was the one trip I didn't have one

 

I need to build a swing out already

 

I do hope I don't need one in these next couple of weeks.

I try to be as prepared as can be on every trip but I won't be this time around.

 

@Kwikvette new job? https://www.instagram.com/reel/Ca7_d-OPWjA/

 

Mans barely working he's just hanging around

 

Be careful AWD with mismatched stuff is how you lose a center diff/t-case

 

Yep!

I do recall that with James' mom's LC.

Thanks for the heads up though