1st Gen Lunchtable Thread - General Discussion

I've heard of welding porn but welding porn?

 

@Ozark_RegCab I'm really stoked about the Ramble cover band. They can do some fun songs to get the group up and singing.

https://youtu.be/gEPmA3USJdI?si=SAGxbJUEAvGE9Dc3

 

I wish

 

I tried doing them myself but couldn't break the bead

 

@Speedytech7 just got something in the mail, thank you again

 

Yassss



Had to knock off a tiny bit of burring from a few holes in my table; the pegs are a perfect 5/8"

 

Camera stuff is always good! I have a lot of photos to go through when I get back. Couple days to go.

 

Hell yeah, can't wait to see them

 

#noideawhatimdoing

 

It's going to take a while to work through them. And clean up. Saw some incredible stuff and wheeled the van hard. Certainly pushed it's limits in a few spots. Couple more nights and then a shower.

 

Time for a Hobo Freight run.

Cutting some 3/16" today and I saw some smoke coming from an unusual area; cutting on the top left piece with my work clamp attached to the bottom right corner where it was smoking.

Work clamp put in a good 2 years of service but time to replace it now.

 

@Ozark_RegCab

Don't even have a 3.4 but when a tool comes up for sale for cheap, you grab it

 

I thought it was a beefed up connecting rod at first

 

Naw, just a tool for the 5VZ

Cheap and easy to make your own, but this was cheaper to buy (used) than to bother cutting and welding some steel to make my own

 

Don’t let that cuck fucks guy see this.

 

It's handy. Worth it when I need to do the tb/wp job.

 

I found a guy down in Conway that’ll work on my truck for $85/hr (he just had one lift and works out of his garage). He also only quoted 3 hours for the rack and an hour each for the LCAs. He has a good rep on the TTA FB group.