1st Gen Lunchtable Thread - General Discussion

Oh hell yeah, post a burnout!!
Why did you have to bleed the brakes though from pulling the 3rd?

 

You have to disconnect the brake lines because the backing plate and drums pull out with the shafts and the rear axle has hard lines

 

Ah gotcha, I haven't actually pulled a 3rd so good to know

 

Not the best but the hard line definitely doesn't have any reach

 

Look at them tire weights

 

Mounted on the inside like a luxury car

 

It's one reason I don't want new rims.

 

But it's No-Nut November...

 

My trucks gonna turn 180k tomorrow, I've already put 45k on her

 

There is functional shit here. But just like everyone else there is bro dozers. We have a lot of competent builders, but a lot of mall crawlers too. Also that truck is obviously a diesel hilux lol, its 4 doors. Anyone in hawaii would be garage queening that thing to never see mud, there are cheaper alternatives lol.

 

Need to drill out the center bore then drill out new bolt pattern and thread the holes

 

Sounds like it shouldn't be a problem. PM me the details when you want to get it done.

 

DT can't seem to balance them out. The tech told me they were all under an ounce

 

Get those little bbs that go inside lol

 

Those actually work pretty well for the 37s on my Jeep

 

I heard they are great for tires that cant get balanced easily

 

https://www.instagram.com/p/BqJis35huhl/?utm_source=ig_share_sheet&igshid=zc06bbfeth8h

 

My ODO is at 228K but I'd be curious to know what the ECU says. I know the engine has been swapped twice so I wouldn't be surprised if a PO swapped the ODO too.

 

I had a set of bias ply 38.5 Swampers and airsoft BBs worked really well.