1st Gen Lunchtable Thread - General Discussion

not sure on your 98 but on 02-04 its on the left side of the bay. Directly below the wiper motor.

 

Clogged or perhaps just not properly seated into the airbox.

 

just take a quick glance at that thread, you'll figure it out. I was going to suggest it last night but you complained about the rain. You're not going to melt. Grab some long needle nose and go check it.

https://www.tacomaworld.com/threads/where-is-the-ac-evaporation-drain-located.232099/

 

But if both floor boards have moisture, it is not going to be the A/C drain. That will probably be either the cowl or windshield.

 

I remember seeing moisture under both floor mats. So I still suspect cowl, but I’ll check the drain too.

 

Mine was windshield, but it had been improperly replaced, and eventually the butyl let go of the metal/paint, and created rust area and leakage. Water ran into my fuse box, integration circuit, and needless to say, it became FUBAR.

 

Oh boy, that’s concerning. I have the original factory windshield so hopefully it isn’t that.

 

lol, right? after being submerged, ya never know what can get in there.

https://en.wikipedia.org/wiki/Candiru#Alleged_attacks_on_humans

 

When I had my windshield replaced, I ended up going back to insurance and having them authorize a re-do. Damn vendor tossed the toyota seal that has the raised lip. Apparently, as long as its not damaged it can be reused. Asshats used some generic seal that had no lip to it. Rain or even water from windshield spray would roll right off and into a partially opened driver side window. Pissed me off. Ended up replacing it with the toyota seal. really have to watch those installers. some dont scrape off all of the old seal and that can lead to pockets which leads to rust.

 

Damn jack asses, why can't people just do the job right the first time. In most cases it's an extra 5 minutes sometimes little more, but just do it right wtf.... Damn what an old grandpa rant, ma bad

 

Not a grandpa/old age rant lol. I want it done right the first time. Trust no one, especially the dealer.

 

So don’t trust the Mexican dude that said he can do it for 50$?

 

@cruiserguy here more laughter for you
https://youtu.be/I9U0caSH_mE

 

wtf

 

https://youtu.be/keWi0PAodhw

 

It’s probably best This wasn’t a thing while i was on a varsity team In high school

 

https://www.instagram.com/hoodlaughss/p/BsikUi7FI47/?utm_source=ig_share_sheet&igshid=rfjnqby2okti

 

Dunno why that shit makes me laugh so much lmao

 

Hoooooleeeeee shiiiiiiittt man I didn't/couldnt even finish watching it

 

Ever seen Apache helicopters videos? These are always crazyhttps://youtu.be/4wJglSZhBno