1st Gen Lunchtable Thread - General Discussion

Well this a7 has proven to be a nightmare. But in other news I can now prove I can remove a a7 supercharger in 25 minutes flat

 

So neither of these part numbers are for the R150F flywheel cover/inspection plate. (11361-0C010)(11361-62010) Might just not use one until I find one in a yard.

I've never understood people that forgot to put them back on after a trans drop.

 

If it’s anything like the auto transmissions a piece of sheet metal cut to shape and some holes and your golden. But I don’t remember what the manuals look like

 

Ordered brass drift punches as well as the o-ring for my manual hubs.

Gaskets arrived today for said manual hubs.

Will have to pay @BartMaster1234 a visit sometime to media blast the cover and body; still undecided on silver or red

 

Looking for a new air compressor and I come across this older screw unit.

Didn't realize how old it was till I read where it was made:



@Blue92 Figured you'd like this:

 

Need to replace my rack and pressure hoses.
Oem vs. low range?
save a little $$ with low range and it comes with tie rods and poly bushings.

What do people lean towards ?

 

Yeah more searching showed me that people cut out cookie sheets in place of them.

 

Use the tears as lube

 

Damn it you beat me to it

 

Tons, 40s and hydro steering

 

https://www.instagram.com/p/B24OdDbg1Rs/?igshid=1r9r3zcrcqd50

 

Beat one yet

 

Putting up my 96 for sale soon so you first gen guys will be rid of me soon on a more permanent basis. Good times for all. Lmao

 

Hurt your feelers so bad you gotta sell it huh

 

87 heater core replacement. An impressive looking job that'll put a little coin in my pocket at my slow assed disabled pace.

 

Hahahaha!!! Good one bolt-on sugartits. Only people like you get offended on the internet. You should report me!

Getting a 2nd gen 2wd double cab long bed prerunner with 120K miles for $5K. Almost 50 more hp, a timing chain instead of a belt, can haul my whole family inside the cab, and no 4wd parts that'll wear out while not being used. Plus I'll actually make money on the deal even after I put what I want on the 2nd gen. It's a win win, win, win, win, etc...

 

How much

 

Rod, nice looking truck!
i looked into selling mine for cash the other day but to my utter dismay found it just ain't worth shit around here
its basically worth more to crush it than to sale out

your online tone is harsh and unfriendly!