1st Gen Lunchtable Thread - General Discussion

I unbolted the DS motor mount and jacked the engine up

 

Probably better than struggling with it more

 

Now I can't separate the axle tube from the diff

 

Heat. There’s FIPG. Then thwack it with a hammer.

 

Little peepee boiz

 

More hammer did it.

I fucked up. I sent in an ADD diff to be built not realizing the diff tube was not a straight swap

 

Wait it's just a stub shafts innit

 

FIFY

 

He wishes people cared that much about him. These people are thirsty af for attention.

 

1990s Honda’s Toyota’s and nissans are #1. Every time someone sells theirs they always come back and say the new one is nothing like the old one. I’ll keep my 90s vehicles over all new ones. I’ll stick to manual trans manual windows etc

 

The 6.0 ate the starter and the crank sensor. Truck is cursed electrically.

 

One of dem Denver Flood Trucks

waits for it*

 

Dude that sucks.

 

Tubes are a straight swap. ADD will have a gear stub and intermediate gear ring you have to remove to swap to a manual hub axle tube.

Use two pry bars.

 

Good lord I’m freezing. I have the entire might of the Pacific Ocean blowing against my office.

 

When I was in high school, most of the kids that drove pickup trucks had rear windows that looked like this. If you had a truck, it was almost expected for you to show what you were carrying. Times have changed.

 

Gear ring? I took the stub out and swapped the tube on

 

Did you move already?

 

I have a hard time with the holiday seasons. Took me a long time to figure out it wasn't the holidays and instead just how shitty my family treats me. Now it feels like I don't belong anywhere

 

That's why you have us band of dejects