1st Gen Lunchtable Thread - General Discussion

oops

must have been thinking about something else. Can do whatever with a diamond since you probably want custom shafts anyways. Could run a Ford 9" third even.


My rear is Toyota 8" third and 3/4 ton Dana 44 spindles and hubs

 

You, my friend, did it for me today

 

Well at least you can predict what you're going to blow up pretty easily. Always nice to have a fuse. Though usually most people don't make their fuse the most expensive part.

 

Grimace huh, not the Hamburglar

 

He always wears this big purple hoodie which is why we all call him Grimace.

 

maybe I should put some cheap hubs on the rear instead of the drive flanges

 

Full float hubs>

 

It is full float

 

Yeahhh just buy a jeep

 

Seems like the air fittings for the ARB didn't make the trip from ECGS.

 

I've noticed from all my friends who have gotten products from them that their quality control consists entirely of... Is there something in the box? If the answer to that question is yes ship to an address. Doesn't matter which address because no matter what they always seem to send the wrong thing anyway. I had a friend that ordered a 529 clamshell and got 3 wrong ratios before finally getting the thing he ordered.

 

Fuck

 

I didn't verify the front before I installed it

 

The rear is correct

 

G'dammit Ryan, now you got me posting in that thread.

Used car price on bill of sale

 

Seems like ECGS spray paints the housing before they do anything with it, there's over spray on the electric connector for the elocker sensor(?)