1st Gen Lunchtable Thread - General Discussion

Pull harder

 

I'm just going in haha. OT was offered so I took it. 6am to 4pm

 

Very well stated my friend. I totally agree.

 

its not getting them out, all but one or two clips came out, enough room to clean the paint behind and spray rustproof stuff behind them

i am going to run into issues with properly putting them back in so they fit properly!
may need the expert help of TW

 

Do you need help brushing your teeth too?

 

i need help to know whether or not i may need a new fender liner to protect the deep gulley in the fender pit in front of the doors

that is a KEY area for rust to develop in that little pocket
the only thing shielding it seems to be a properly fitting and snug liner from snow and slop accumulating inside there
please take this issue seriously

 

Are yours damaged?

 

one might be, it does not appear to sit flush with the body panel, there was so much dirt, sand and gunk between the liner and steel i have to do some deep cleaning between them
i can get pics later if it can help diagnose this

 

I don’t care enough to look at a picture

 

Sometimes in life you gotta figure stuff out on your own.

 

Just do the self cleaning mod

 

i would like pics of what they are supposed to be like
do you know of any manual of how to properly reinstall the liners and clips?
the weather is supposed to turn nasty this weekend so time is of the essence!

 

looks like you have fender flares, i have the chrome wheel moldings
they should be somewhat similar though with the liners
i sprayed FF all up in that passenger side yesterday, almost a whole can!

 

Line the holes up, insert clip.

 

if i fuck it up though i fear that corrosion can set in very quickly

 

this is what i do not understand
the clip is over the top of the chrome molding piece but only on this one area in the front on both sides
that white stuff is road chemical crap

 

What is this hose for, I've seen other engines with a filter in that location.

 

Have you ever taken the chrome piece off? Might wanna

 

I killed one in my driveway while I was working on my truck. It wasn't big like that though, only about 1" in diameter.

 

the two on the passenger side have been replaced before due to some parking lot damage and needed the fender repaired and the other got bent
the driver side moldings have never been removed until i took them off a few days ago
they were hellish dirty on the inside, but forgot to take pics before i washed and scrubbed the insides of them out