1st Gen Lunchtable Thread - General Discussion

That side is just the return vent hose for the PCV. The PCV should be on the other end of the valve cover.

 

satin red driveshafts??? until i would need to get new ones due to possible vibes that have not been diagnosed yet

 

Ujoint or carrier bearing


But I’m sure you don’t know how to check.

 

yes you are correct
i have read on TW that one of those will entail a whole new driveshaft if its bad, i think its the cardan joint but i am not sure, one of them that cannot be replaced or rebuilt easily, best option is to pork out close to $700 for a new aftermarket shaft

 

The cardan joint only has half the ujoints.

 

If its not a 5 speed, dont waste your time.

 

Fresh air intake for PCV, leave it alone

 

my thinking is its not any ujoints since it hauls at high rates of speed with no shimmy or wobble wobble
its only at a certain RPM range where i notice it happening so it baffles me
but this stuff is not in my wheelhouse

 

Uh oh gentlemen, is this the V6 reg cab MT 4x4 I've been waiting for?
Thoughts? Or someone swoop it so it's not tempting me...

https://reno.craigslist.org/cto/d/silver-springs-winter-ready-1995-toyota/7029084080.html

 

Definitely the droid you've been looking for.

 

Big oooof when you get to the last picture
1999 Toyota Tacoma TRD Off Road
http://www.ksl.com/auto/listing/6106766

 

Same here, 2 for me tho. One was fixed at 11 and the other at 21.

 

Looks like mostly surface rust. Could probably be easily fixed. Hard to tell just from that picture tho.

 

I wouldn’t risk it, I bet it’s pretty rotten under that seal. Would be a pain to fix well enough to get a good deal again.

 

I probably wouldn't either but I guess it all depends on what's available and if you are willing to travel or not.

 

I’ve already got one rust bucket, don’t really need another haha

 

That's a cool build.

 

Get a 4.0 with the 6 speed. Such a fun truck to drive.

 

That’ll be a vent line for the valve cover. The PCV should be on the other end of it. I have the part number if you need it, I changed it when I replaced my valve cover and PCV.

 

@BartMaster1234 I dropped something off at the post office for you this morning