1st Gen Lunchtable Thread - General Discussion

To whoever was talking about wheels. https://atlanta.craigslist.org/nat/wto/d/buford-enkei-alloy-wheels-15-inch/7043132430.html

 

where is this at, i need a cross country road trip!

 

That's how this game works

 

Ask @eon_blue

I've passed by it many times but never been. Will be interesting to check out some new trails and camp

 

Man I can't imagine what that was like. 33s on 410s is what I have, though @Kwikvette is auto trans so his experience might differ a little I'm not sure. With a manual it's not bad but at 80mph I'm pushing just over 3k rpms

 

That supercharger is in the way, I'll just take it off your hands....

And @what road

 

i did not make it around to removing those
just the heavy duty grommets that the arch moulding bolts go into, it was challenging and very time consuming

 

They're good for snapping the heads off those plastic clips then pushing the rest through the hole, using a knife always ends up fucking up the knife or the surface (or both), regular scissors never cut through them easily. I think HF sells those body panel pliers I'll have to grab one

 

Yep

 

those are much different than the alloys i have but look interesting

 

Fyi

I get my package tomorrow; I won't be alone anymore

 

wot game

 

I've had that one for 10 years now. Panic strikes whenever I can't find it.

 

This one

 

Every other Tacoma owner

 

I had one of those kits but I lost it

 

yeah they were brittle even hard to cut at them with a side cutter tool
the new AM chinese garbage ones i snapped back in were bendable on the outer ring

 

Im not a hooligan, I can keep up with my tools. Never lost a 10mil yet. I have found one or two in the junkyard though...

 

Yep.. If somebody looked at in my tool boxes they would think I have some type of a weird 10, 12, and 14mm socket fettish.. You can't have too many.