2014 Quick Wiring Diagram Entune - No Nav (Bit10 DSP Install)

Hey guys,

I'm looking for a quick wiring diagram to the Non-navigation Entune head unit. Not sure how much it matters, but I have a Double Cab PreRunner SR5, 2014 as I previously said.

What I'm trying to do is install an Audison BitTen DSP and can't for the life of me find a diagram that I can use as a quick reference. Does anybody happen to have one floating around or know where I can get it?

Thanks in advance!

 

I installed an Audison Bit ten, amp, and speakers w/ the stock Head Unit a few months ago and the combo sounds awesome. Mine is a 2014 DC OR Entune plus no JBL. Sound is night and day . Full pin out for both plugs of the wire harness are included in this thread:

http://www.tacomaworld.com/forum/au...-converter-help-needed-harness-wires-tap.html

Order the Best Kits adapters and you won't have to splice into the wire harness. I extended the speaker outputs, 12V and ground , ran the wire bundle down the dash on the left side of the glove box and under the center console to the seat. Audison under driver seat and amp under passenger seat.

 

You're the man. Thanks for the info.

I'm doing something similar, running all of my extension wires down the left side of the glove box to my BitTen under the passenger seat.

You aren't experiencing any floor noise with that setup? I've spoke to a few people who mentioned that I will probably get a whining with the BitTen due to integrating the factory head unit.

Did you tune the DSP yourself?

 

+1 on the Best Kits adapters. I used Metra and had to modify the adapters to fit, but they worked.

FWIW I'm doing a similar install using a miniDSP. I don't have the DSP installed yet but do have a bit of floor noise. I doubt the miniDSP will eliminate it. Not sure about the bit Ten.

 

also, you didn't only tap into the speaker wires when you did the install, did you? The BitTen calls for the Bluetooth inputs and others, no?

 

thanks Skoot! I'm gonna pick up some adapters right now.